Installation Sheet

Installation Guide
SKU#32285
USA/Canada: 1-800-4 KOHLER 1446238_8_A
www.kohler.com
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damage. This product is for indoor use only. Observe all local codes.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto
a clean and soft cloth to protect finish. Confirm all parts are included.
2. Loosen screws (G) and then remove mounting plate (B) from canopy
(F).
3. Attach mounting plate (B) onto outlet box with screws (D). Ensure
ground screw (C) is attached to mounting plate (B).
4. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture green or bare ground wire to the green or bare copper
wire in outlet box with wire nut (A) or fasten onto ground screw (C)
on mounting plate.
5. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture white wire to the white wire in outlet box with wire
nut (A). Wrap the wire connector with electrical tape so that the
tape seals the end of wire nut (A), see diagram 1.
6. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten the fixture black wire to the black wire in outlet box with wire
nut (A). Wrap the wire connector with electrical tape so that the
tape seals the end of wire nut (A), see diagram 1.
7. Insert quick connector (E) into the opposing quick connector end.
8. Tuck wires carefully inside outlet box. Attach the canopy (F) onto
mounting plate (B) with screws (G).
9. Place decorative ring (L) over Shade (J). Then set decorative ring (L)
on the lip of shade (J).
10. Remove socket ring (K) from socket (I). Then install metal shade (J)
to central base (H) with socket ring (K).
11.
NOTICE: Do not exceed recommended wattage. Rated Max 100 W,
Type A/B/C/G. (Bulb(s) not included).
12. Install bulb to the socket (I).
13. Restore power to circuit at breaker or fuse box.
CLEANING: Please clean fixture with a soft and dry cloth ONLY. Clean
glass with a mild soap.
Approved fastener
(
Wire nut
)
Electrical ta
p
e
Phillips &
Flathead Screwdriver
Wire
Cutter/stripper
Electrical Current
Tester
Electrical
Tape
Diagram 1

Summary of content (4 pages)