Installation Guide

2. Install the Legs
CAUTION: Risk of personal injury. Wear personal
protective equipment and obtain sufficient help to carefully
lift or move the bath. Cast iron baths are extremely heavy.
Lift the bath properly to avoid personal injury.
Place protective floor covering or a throw rug near the installation
area. This will prevent damage to the floor and bath when the
bath is set down.
With help, remove the bath from its carton and place it on top of
the protective floor covering.
Lift the outlet end of the bath until sufficient clearance is obtained
to attach the two front legs.
Insert the fastening bolt through the two washers.
With the load lug resting on the flat of the interior leg, align the
leg with the attachment lug.
Insert the fastening bolt, then wrench tighten.
Repeat the above procedure for the remaining legs.
3. Install the Bath
CAUTION: Risk of personal injury. Wear personal
protective equipment and obtain sufficient help to carefully
lift or move the bath. Cast iron baths are extremely heavy. If
the cast iron bath is not lifted properly, personal injury may
occur.
Flat Washers (2)
Leveling Bolt
Attachment Lug
Fastening Bolt
Load Lug
Bath
Kohler Co. 5 1084218-2-C