Installation Guide

Product Information (cont.)
Connections and Service Access
NOTICE: Provide unrestricted service access to the blower motor. You must provide access for servicing
the blower motor and controls. The access must be located immediately next to the blower motor. Study
the roughing-in information packed with the bath with airjets.
Before installation, ensure that there is proper access to the blower motor and final connections. If the blower
motor is installed in an enclosed area, an access panel is required at the blower motor. This panel should be
at least 34″ (864 mm) wide and 15″ (381 mm) high.
Table of Contents
IMPORTANT SAFETY INSTRUCTIONS ................................................ 2
Product Information ............................................................... 2
Electrical Requirements .......................................................... 2
Product Notices ................................................................ 2
Factory Assembled Features ...................................................... 2
Connections and Service Access ................................................... 3
Tools and Materials ............................................................... 3
Before You Begin ................................................................. 4
Construct the Site - Wood Frame ..................................................... 5
Construct the Site - Concrete ........................................................ 6
Secure the Bath .................................................................. 7
Install the Plumbing ............................................................... 8
Connect the Electrical Service - Standard ............................................... 9
Remove the Blower Motor and Check Valve - Remote ..................................... 10
Mount the Blower Motor and Check Valve - Remote ...................................... 11
Terminate the Blower Power Cable - Remote ........................................... 12
Install Blower Power Cord at Control - Remote .......................................... 14
Make Supply Power Connections - Remote ............................................ 15
Complete the Installation .......................................................... 16
Test Run the Bath ............................................................... 16
Operate the Keypad .............................................................. 19
Troubleshooting ................................................................. 20
Tools and Materials
Silicone Sealant
Plus:
• Conventional woodworking tools and materials or
conventional masonry tools and materials,
as appropriate
• Drop cloth
• Construction Adhesive (optional)
• Cement or Mortar (optional)
• 2x4s or 2x6s (optional)
Kohler Co. 3 1035472-2-K