Specification

Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
43″ (1092 mm) x 20-1/2″ (521 mm)
Basin area,
top
53-1/2″ (1359 mm) x 32-1/8″ (816 mm)
Weight 110 lbs (50 kg)
To overflow:
Water depth 15″ (381 mm)
Capacity 57 gal (215.9 L)
* Approximate measurements for comparison only.
Drop-in cutout
dimensions:
58-1/2″ (1486 mm) x 40-1/2″ (1029
mm)
Blower motor Heater V Hz A
300 W 120 60 5
Minimum access panel blower motor (required):
20″ (508 mm) W x 15″ (381 mm) H
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 5 A, 60 Hz
Blower motor is supplied with a 24″ (610 mm)
grounding-type plug-in cord.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 35 lbs/square foot (171 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
Recommended faucet area
1-1/2" OD
42" (1067 mm)
10-13/16"
(275 mm)
60" (1524 mm)
2-7/8" (73 mm)
3" (76 mm)
No change in measurements if connected with
drain illustrated. (K-11677)
1-1/2"
(38 mm)
1-1/4"
(32 mm)
Tile Flange
Detail
Drop-In Rim
Detail
1-1/2" (38 mm)
19-1/2"
(495 mm)
1" (25 mm) from the
Floor to the Bottom
of the Drain
3-1/2"
(89 mm)
3-1/8"
(79 mm)
21"
(533 mm)
Blower/Control Access
20" (508 mm) W x
15" (381 mm) H Min
Product Diagram
WINDWARDTM
WINDWARDTM BATH WITH AIRJETS
Page2of2
1079327-4-
E