Dimensions Guide

Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
43″ (109.2 cm) x 20-1/2″ (52.1 cm)
Basin area, top 53-1/2″ (135.9 cm) x 32-1/8″ (81.6 cm)
Weight 110 lbs (50 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 57 gal (215.9 L)
* Approximate measurements for comparison only.
Drop-in cutout dimensions:
58-1/2″ (148.6 cm) x 40-1/2″ (102.9 cm)
Blower motor Heater V Hz A
300 W 120 60 5
Minimum access panel blower motor:
20″ (50.8 cm) W x 15″ (38.1 cm) H required
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 5 A, 60 Hz
Locate the outlet behind the bath and within 24″ (61 cm)
of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 35 lbs/square foot (171 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
2-7/8" (7.3 cm)
3" (7.6 cm)
Recommended faucet area
1-1/2" OD
42" (106.7 cm)
21"
(53.3 cm)
10-13/16"
(27.5 cm)
60" (152.4 cm)
3-1/8" (7.9 cm)
21" (53.3 cm)
1-1/4" (3.2 cm)
3-1/2" (8.9 cm)
19-1/2"
(49.5 cm)
1-1/4" (3.2 cm)
1" (2.5 cm) from the
Floor to the Bottom
of the Drain
Drop-In Rim
Detail
Tile Flange
Detail
1-1/4"
(3.2 cm)
1-1/2"
(3.8 cm)
No change in measurements if connected
with drain illustrated. (K-11677 or K-11677M)
Blower/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H Min
Product Diagram
WINDWARDTM
WINDWARDTM BATH WITH AIRJETS
Page2of2
1079328-4-
D