Dimensions Guide

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 43″ (109.2 cm) x 20-1/2″ (52.1 cm)
Basin area, top 53-1/2″ (135.9 cm) x 32-1/8″
(81.6 cm)
Weight 120 lbs (55 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 57 gal (215.9 L)
* Approximate measurements for comparison only.
Drop-in cut-out dimensions:
58-1/2″ (148.6 cm) x 40-1/2″ (102.9 cm)
Pump: V Hz A
1-speed 120 60 7.5
Minimum access panel pump/control:
20″ (50.8 cm) W x 15″ (38.1 cm) H required
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(61 cm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under the whirlpool must provide for a minimum
of 36 lbs/square foot (174 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
1-1/2" OD
10-13/16" (27.5 cm)
60" (152.4 cm)
42" (106.7 cm)
3/8" (1 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Recommended faucet area
21" (53.3 cm)
1-1/4" (3.2 cm)
Tile Flange
Detail
1-1/4"
(3.2 cm)
3-1/2"
(8.9 cm)
1-1/4"
(3.2 cm)
3-1/8"
(7.9 cm)
21"
(53.3 cm)
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
Product Diagram
WINDWARD
®
WINDWARD
®
BATH WHIRLPOOL WITH INTEGRAL APRON
Page2of2
1047213-4-
D