How to Guide

Product Information
Applicable product:
Drop-in bath with airjets K-11343-G
Drop-in bath with airjets and chromatherapy K-11343-GCR
Fixture*:
Bathing well:
Basin area 46-3/4″ (118.7 cm) x 21-5/8″ (54.9 cm)
Top area 69-15/16″ (177.6 cm) x 34-3/8″ (87.3 cm)
Weight 130 lbs (59 kg)
To overflow:
Water depth 16-1/2″ (41.9 cm)
Capacity 71 gal (268.8 L)
* Approximate measurements for comparison only.
Included component:
Cut-out template 1054544-7
Blower
motor/control:
Heater V Hz A
300 W 220-240 50/60 3
Recommended accessories:
Bath cable drain K-7214
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Blower motor/control: 220-240 V, 15 A, 50/60 Hz
Notes
Install this product according to the installation guide.
NOTICE: If the blower motor and check valve are relocated, the
following two procedures are required: 1. Provide two access
panels. Locate one access panel at the blower motor/control
location and the other access panel at the control box. 2. Relocate
the blower motor and the check valve together. Do not relocate one
without the other.
Floor support under bath must provide for a minimum of 42 lbs
(206 kg) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
A blower motor/control access panel is required.
Fixture dimensions are nominal and conform to tolerances in ANSI
Standard Z124.1.2.
22-1/4"
(56.5 cm)
1-7/8"
(4.8 cm)
35-5/8" (90.5 cm)
35-5/8" (90.5 cm)
71-5/8" (181.9 cm)
1-1/2" OD
2-7/8" (7.3 cm)
3" (7.6 cm)
3-1/2" (8.9 cm)
Blower/Control Access
30" (76.2 cm) W x
15" (38.1 cm) H
No change in measurements if connected
with drain illustrated. (K-7214)
1054544-1-D 2 Kohler Co.