Installation Guide

Confirm Proper Operation (cont.)
Fill the whirlpool to a water level at least 2″ (5.1 cm) above the top of the highest jet.
NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C).
Operating Sequence
Press the air actuator to turn on the whirlpool jets.
Adjust each jet for optimum air/water mixture. Turn the trim ring clockwise to reduce the air flow,
and counterclockwise to increase the air flow.
If equipped with a heater, the heater will engage automatically when the pump is turned on and
will disengage when the pump is turned off. The heater will not turn on if the water temperature
exceeds 104°F (40°C).
Press the air actuator a second time to turn off the whirlpool.
NOTE: The optional K-1717 Timer Kit automatically stops the whirlpool after approximately 20 minutes of
operation.
Kohler Co. 15 1011090-2-C