Installation Guide

3. Disconnect the Pump
NOTE: No cutting of the whirlpool harness (piping) is required for this installation. Any cutting of the
harness will void the warranty.
Models with Support Blocks
Disconnect the pump and heater (if equipped) from the shipping location by cutting the two
banding straps with tin snips.
Relocate the pump and heater (if equipped) next to the customized inlet/outlet connections of the
whirlpool harness. The pump may protrude beyond the rim of the bath. See the roughing-in details.
Move the pump and heater (if equipped) aside.
Models with Support Pan
Disconnect the pump and heater (if equipped) from the support pan.
Locate the pump support bracket and remove it from the whirlpool harness.
Relocate the pump and heater (if equipped) next to the customized inlet/outlet connections of the
whirlpool harness. The pump may protrude beyond the rim of the bath. See the rough-in details.
Move the pump and heater (if equipped) aside.
1011090-2-C 6 Kohler Co.