How to Guide

Product Information
Applicable products:
Bath whirlpool with heater – drop-in K-1154-H
Bath whirlpool with heater – tile flange K-1154-FH
Fixture*:
Basin area:
Bathing well 44″ (1118mm)x36″ (914 mm)
Top area 56″ (1422 mm) x 43″ (1092 mm)
Weight 70 lbs (31.8 kg)
To overflow:
Water depth 15″ (381 mm)
Capacity 76 gal (288 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7.5
Heater: kW V Hz A
1.5 120 60 12.5
Required Electrical Service
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater: 120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within 24″
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
36 lbs/square foot (176 kg/square meter) loading.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
Drop-in Rim Detail
1-1/2"
(38 mm)
Tile Flange Detail
1-1/4"
(32 mm)
25" (635 mm)
135˚
52-1/2"
(1334 mm)
39-3/4" (1010 mm)
13"
(330 mm)
4-7/8"
(124 mm)
Pump/Control Access
20" (508 mm) W x 15" (381 mm) H
26" (660 mm)
30-3/4" (781 mm)
56-1/2"
(1435 mm)
30-3/4"
(781 mm)
54"
(1372 mm)
26" (660 mm)
54" (1372 mm)
2-5/8"
(67 mm)
20-1/2"
(521 mm)
2-7/8"
(73 mm)
3" (76 mm)
1/2" (13 mm)
1-1/2" OD
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
Cut-out Detail
Drop-in Rim Style
Roughing-In
K-1154-H, K-1154-FH
PROFLEX
®
5454
BATH WHIRLPOOL WITH HEATER
PROFLEX
®
5454 BATH WHIRLPOOL WITH HEATER
1012956-1-
E