Dimensions Guide

Pump/Control Access
Notes
Required Electrical Service
Measure your actual product for rough-in details.
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
240 V, 20 A, 50/60 HzPump, Heater:
Technical Information
All product dimensions are nominal.
This bath is designed for drop-in installation only.
It is not suited for use in a three wall alcove with
an overhead shower.
Drop-inInstallation:
EndDrain location:
46" x 30" (1168 mm x 762 mm)Basin area, bottom:
57" x 34" (1448 mm x 864 mm)Basin area, top:
130 lbs (59 kg)Weight:
50 lbs/ft² (244.1 kg/m²)Minimum floor load:
16" (406 mm)Water depth:
95 gal (359.6 L)Water capacity:
Drop-in, 1043292-7, required, includedTemplate:
Pump: 240 V, 11 A, 50/60 Hz
Heater: 240 V, 6.25 A, 50/60 Hz, 1500 W
Electrical component
rating:
VariablePump speed:
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
7-28-2017 02:40
Bancroft
®
5.5' Whirlpool Bath
K-1158-H2