How to Guide

Product Information
Applicable product:
Bath whirlpool with custom pump and
heater – drop-in
K-1160-HD
Fixture*:
Basin area:
Bathing well 52” (1321 mm) x 38-3/4” (984 mm)
Top area 61” (1549 mm) x 46-1/4” (1175 mm)
Weight 131 lbs (59.4 kg)
To overflow:
Water depth 15” (381 mm)
Capacity 96 gal (363.6 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7.5
Heater: kW V Hz A
1.5 120 60 12.5
Minimum access panel
(required):
20″ (508 mm) W x
15″ (381 mm) H
Required Electrical Service
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within 24”
(610 mm) of the pump and heater.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
39 lbs/square foot (189 kg/square meter) loading.
Fixtures conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
Ø 1-1/2"
3" (76 mm)
60" (1524 mm)
27-1/2" (699 mm)
135˚
Recommended faucet area
35"
(889 mm)
63"
(1600 mm)
35"
(889 mm)
Pump/Control Access
29" (737 mm)
13-1/8"
(333 mm)
4-7/8"
(124 mm)
43-3/4"
(1111 mm)
19-1/2"
(495 mm)
21"
(533 mm)
1/2" (13 mm)
2-7/8"
(73 mm)
2-7/8"
(73 mm)
57-1/2"
(1461 mm)
Drop-In Rim Style
Cut-Out Detail
Drop-In Rim Detail
1-1/2"
(38 mm)
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
29"
(737 mm)
60"
(1524 mm)
Roughing-In
K-1160-HD
TERCET
®
BATH WHIRLPOOL WITH CUSTOM PUMP AND HEATER
TERCET
®
BATH WHIRLPOOL WITH CUSTOM PUMP AND HEATER
1041918-1-
D