How to Guide

Product Information
Applicable product:
Bath whirlpool – custom pump K-1164-CB
Fixture*:
Bathing well:
Basin area,
bottom
55-1/4″ (140.3 cm) x 23-1/2″ (59.7 cm)
Basin area, top 64-1/2″ (163.8 cm) x 32″ (81.3 cm)
Weight 112 lbs (50.9 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 75 gal (284.1 L)
* Approximate measurements for comparison only.
Included components:
Cut-out template 1042557-7
Pump: V Hz A
1-speed 120 60 7.5
Minimum access panel pump/control:
20″ (50.8 cm) W x 15″ (38.1 cm) H required
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24”
(61 cm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
36 lbs/square foot (177 kg/square meter) loading.
Pump must be relocated to custom position at the time of
installation. Provide adequate clearance.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
Recommended faucet area
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
Pump/Control Access
8" (20.3 cm) Max
21"
(53.3 cm)
3-1/8" (7.9 cm)
3-1/2" (8.9 cm)
21"
(53.3 cm)
19-1/2"
(49.5 cm)
1-1/2"
(3.8 cm)
Drop-In Rim Detail
1-1/2" OD
10-13/16" (27.5 cm)
72" (182.9 cm)
3" (7.6 cm)
2-7/8" (7.3 cm)
3/8" (1 cm)
42" (106.7 cm)
Roughing-In
K-1164-CB
SUNWARD
®
BATH WHIRLPOOL
SUNWARD
®
BATH WHIRLPOOL
1041946-1-
E