How to Guide

Product Information
Applicable product:
Bath whirlpool K-1164-HB
Fixture*:
Bathing well:
Basin area,
bottom
55-1/4″ (140.3 cm) x 23-1/2″ (59.7 cm)
Basin area, top 64-1/2″ (163.8 cm) x 32″ (81.3 cm)
Weight 112 lbs (50.9 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 75 gal (284.1 L)
* Approximate measurements for comparison only.
Included components:
Cut-out template 1042557-7
Pump: V Hz A
1-speed 120 60 7.5
Heater: kW V Hz A
1.5 120 60 12.5
Minimum access panel pump/control:
20″ (50.8 cm) W x 15″ (38.1 cm) H required
Required Electrical Service
Two dedicated circuits are required, each protected with
a Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within 24”
(61 cm) of the pump and heater.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
36 lbs/square foot (177 kg/square meter) loading.
The suction line extends 1” (2.5 cm) beyond the edge of the
rim. The pump base extends 1-1/8” (2.9 cm) beyond the edge
of the rim. Modify the framing as needed.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
Drop-In Rim Detail
1-1/2" OD
10-13/16" (27.5 cm)
72" (182.9 cm)
3" (7.6 cm)
2-7/8" (7.3 cm)
3/8" (1 cm)
42" (106.7 cm)
8" (20.3 cm) Max
Recommended faucet area
Pump/Control Access
21" (53.3 cm)
3-1/8" (7.9 cm)
3-1/2" (8.9 cm)
21" (53.3 cm)
19-1/2"
(49.5 cm)
1-1/2"
(3.8 cm)
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
Roughing-In
K-1164-HB
SUNWARD
®
BATH WHIRLPOOL
SUNWARD
®
BATH WHIRLPOOL
1041947-1-
E