Installation Guide

Important Information
WARNING: When using electrical products, basic precautions should always be followed,
including the following:
DANGER: Risk of accidental injury or drowning. This appliance is not intended for use by
persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge.
Children should be supervised to ensure that they do not play with this appliance.
WARNING: Risk of electric shock. Connect only to a circuit protected by a Ground-Fault
Circuit-Interrupter (GFCI)*.
WARNING: Risk of electric shock. A qualified electrician should make all electrical connections.
WARNING: Risk of electric shock. Disconnect power before servicing.
WARNING: Risk of personal injury. Parts containing live parts, except parts supplied with safety
extra-low voltage not exceeding 12 V, must be inaccessible to a person in the whirlpool.
WARNING: Risk of injury or property damage. Please read all instructions thoroughly before
beginning installation, including the following requirements.
NOTICE: Follow all local plumbing and electrical codes.
Install to permit access for servicing.
A green with yellow stripe lead wire is provided within the wiring compartment. To reduce the risk of
electrical shock, connect this wire to the grounding terminal of your electric service or supply panel with
copper wire equivalent in size to the circuit conductor supplying this equipment.
A pressure wire connector is provided on the exterior of the pump or control within this unit to permit
connection of a bonding conductor between this unit and all other exposed metal in the vicinity, as needed to
comply with local requirements.
Grounding is required. The unit should be installed by a qualified service representative, and grounded.
Building materials and wiring should be routed away from the pump body and other heat-producing
components of the unit.
*Outside North America, this device may be known as a Residual Current Device (RCD).
Important Product Information
Product Notices
WARNING: Unauthorized modification may cause unsafe operation and poor performance of
the bath. Do not relocate the pump, or make other modifications to the circulating system, as this
could adversely affect the performance and safe operation of your bath. Kohler Co. shall not be
liable under its warranty or otherwise for personal injury or damage caused by any such
unauthorized modification.
Product Inspection
Carefully unpack the product, and inspect the unit for damage. Return the unit to the carton during
construction to prevent damage.
Factory-Assembled Features
Factory installed components include pump, level sensors, inline heater, submerged chromatherapy lights
(optional), control and switch. The pump and piping are factory-assembled.
1054216-2-C 2 Kohler Co.