Installation Guide

Roughing-In - Required Components

For best results, follow the suggested installation sequence below. Speciﬁc, detailed instructions for each

installation step are located on the remaining pages of this installation guide.

NOTE: The illustration above shows a typical installation with the preferred installation locations for the

user interface and control ampliﬁer.

Suggested Installation Sequence

Determine the installation location for the bath, user interface, and control ampliﬁer.

NOTICE: Use wood stud or concrete framing. Metal framing may adversely affect the vibracoustic quality

of the product.

Determine the location for the access panel (required) for servicing the control ampliﬁer.

Route all plumbing supply lines for the bath.

Install the bath and drain.

Route the transducer cables to the area chosen for the control ampliﬁer.

If equipped, route the optional chromatherapy cable to the area chosen for the control ampliﬁer.

Route the user interface cable from the control ampliﬁer area to the user interface location.

Install an electrical outlet within 24″ (610 mm) of the area chosen for the control ampliﬁer.

Install the control ampliﬁer.

Connect the transducer, user interface, optional auxiliary device, and chromatherapy cables (if

equipped) to the control ampliﬁer.

Finish the walls, and install the required access panel for the control ampliﬁer.

User Interface

10"

(254 mm)

24" (610 mm)

Chromatherapy

Cable (If

Equipped)

Access

Panel

Control

Amplifier

Drain

Overflow

Transducer

Cables

1188012-2-C 4 Kohler Co.