Installation Guide

4. Install the Supply Piping and Valve
Back-to-Back Installation
NOTICE: Do not install the valve body upside down.
Route the supplies and install the valves. Refer to the roughing-in
illustration for your installation.
NOTE: One valve will have reversed supply connections, hot
supply to ″COLD″ inlet and cold supply to ″HOT″ inlet.
Connect the water supplies as shown. Use sealant tape on all
threaded connections.
Install 2x4 bracing behind the plate (not shown).
Proceed to the “Route the Piping” section for your installation
configuration.
Cold Supply
Hot Supply
1128093-2-E 10 Kohler Co.