How to Guide

Product Information
Applicable products:
Bath whirlpool with integral apron – left
drain
K-1209-LA
Bath whirlpool with integral apron –
right drain
K-1209-RA
Fixture*:
Basin area
Basin area bottom 47″ (1194 mm) x 20″ (508 mm)
Basin area top 53″ (1346 mm) x 23″ (584 mm)
Weight 100 lbs (45.4 kg)
To overflow
Water depth 14-1/2″ (368 mm)
Capacity 64 gal (242.3 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7.5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 48 lbs/square foot (234 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
Rim-mount faucet installations: Before drilling the mounting
holes, ensure the faucet does not interfere with the drain
overflow and circulating system.
Deck-mount spout installations: Consult local and national
codes for minimum air gap requirements.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
No change in measurements if connected with drain
illustrated. (K-7161-AF or K-7161M-AF)
3"
(76 mm)
20"
(508 mm)
8-11/16"
(221 mm)
1-11/16"
(43 mm)
60" (1524 mm)
3"
(76 mm)
1" (25 mm)
32" (813 mm)
16"
(406 mm)
1-1/4"
(32 mm)
1/2" (13 mm)
R. Max
Integral
Flange Detail
2-7/8"
(73 mm)
Recommended Faucet Area
1-1/2" OD
Roughing-In
K-1209-LA, K-1209-RA
HOURGLASS
®
32
BATH WHIRLPOOL WITH INTEGRAL APRON
HOURGLASS
®
32 BATH WHIRLPOOL WITH INTEGRAL APRON
1014687-1-
D