Installation Guide

7. Complete the Installation

Flush Installations

Install water-resistant wall material to within 1/4″ (6 mm) of the module edge.

Install desired trim (not provided) around the unit to conceal the module edge.

Also install trim along the bottom apron edge.

Alcove Installations

Install water-resistant wall material around the unit to conceal the module edge.

All Installations

Apply a bead of silicone sealant to the nailing-in ﬂanges.

Install water-resistant wall material with the paperbound edge a maximum of 1/4″ (6 mm) above

the ﬁnished, concave surface of the module.

Tape and mud the wall material.

Seal around the valving and outlets with silicone sealant or plumbers putty.

Install the faucet and drain trim according to the faucet manufacturer’s instructions.

If applicable, install the grab bars and towel bars. Refer to the accessory manufacturer’s instructions

to properly secure the accessory to the wall surround.

If applicable, install the shower door according to the manufacturer’s instructions. Only apply

sealant where instructed to do so.

Clean up with a non-abrasive cleaner.

Flush Installation

(Top Down View)

2x4 Studs

Module

1x2 Brace

Water-Resistant

Wall Material

Tr im

1/4" (6mm) Gap

Alcove Installation