How to Guide

Product Information
Applicable product:
Bath whirlpool – drop-in K-1224
Bath whirlpool with integral flange and
left drain – 3-wall alcove
K-1224-L
Bath whirlpool with integral flange and
right drain – 3-wall alcove
K-1224-R
Fixture*:
Bathing well:
Basin area, bottom 48″ (1219 mm) x 24″ (610 mm)
Basin area, top 59″ (1499 mm) x 30″ (762 mm)
Weight 110 lbs (49.9 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 67 gal (253.6 L)
* Approximate measurements for comparison only.
Drop-in cutout: 64″ (1626 mm) x 34″ (864 mm)
Pump: V Hz A
1-speed 120 60 7.5
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI).
Pump/control 120 V, 15A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(610 mm) of the pump
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
48 lbs/square foot (232 kg/square meter).
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. If installing a spout on the faucet
deck, consult local and national codes for minimum air gap
requirements.
The apron must be installed before the finished floor and wall
materials are installed.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
No change in measurements if connected with drain
illustrated. (K-7161-AF or K-7161M-AF)
Pump/Control Access
(If Apron Is Not Used)
20" (508 mm) W x
15" (381 mm) H
18-1/2"
(470 mm)
20"
(508 mm)
8-11/16" (221 mm)
1-11/16"
(43 mm)
3"
(76 mm)
2-7/8"
(73 mm)
1" (25 mm)
35-7/8" (911 mm)
3-1/2"
(89 mm)
18"
(457 mm)
66" (1676 mm)
1-1/2" OD
1-1/4"
(32 mm)
1/2" (13 mm)
R. Max
Integral
Flange Detail
1-1/2"
(38 mm)
Drop-in Rim
Detail
Recommended Faucet Area
Roughing-In
K-1224,K-1224-L, K-1224-R
MARIPOSA
®
BATH WHIRLPOOL
MARIPOSA
®
BATH WHIRLPOOL
1014724-1-
D