Installation Guide

9. Complete the Finished Walls
Cover the framing with water-resistant material.
Provide suitable access to the control amplifier.
Install the finished wall material.
Drill a 5/8″ (16 mm) hole through the wall material where the user interface will be installed. Refer
to the ″Roughing-in - Required Components″ section for the recommended location.
Route the user interface cable through the hole in the wall material, and tape or otherwise secure
the cable so it will not fall between the walls.
IMPORTANT! Kohler Co. strongly recommends the use of 100% silicone sealant as instructed. Other
sealants with high filler contents should be avoided, as they may shrink, separate, and peel over time.
Seal the joints between the bath rim and the finished wall with a 1/8″ (3 mm) bead of 100% silicone
sealant.
Install the faucet trim.
Concrete Construction
Apply mortar and tile to the wall and surround material as needed. Install tile to within 1/4″ (6
mm) of the bath deck, making sure the tile covers the screw heads in the flange.
IMPORTANT! Kohler Co. strongly recommends the use of 100% silicone sealant as instructed. Other
sealants with high filler contents should be avoided, as they may shrink, separate, and peel over time.
Apply a 1/8″ (3 mm) bead of 100% silicone sealant where the tile meets the bath surface.
Install the faucet trim.
Water-Resistant
Wallboard
5/8" (16 mm) User Interface Hole
Finished Material
Apply 100% silicone
sealant.
100% Silicone
Sealant
24"
(610 mm)
10"
(254 mm)
Kohler Co. 13 1188012-2-D