Installation Guide

4. Route the Cables
IMPORTANT! Several of the included bath components will be powered by the control amplifier via 25’
(7.6 m) cables. Plan the location of the control amplifier so the cables will reach without being under
tension.
Route the Cables Through the Framing
Carefully cut the cable tie securing the coiled transducer wires to the bath.
Route the transducer wires through the framing to the control amplifier location, drilling 1″ (52 mm)
holes where needed.
If equipped, route the chromatherapy cable from the bath to the planned amplifier location. Follow
the same route as the transducer wires.
Route the user interface cable through the framing from the planned user interface location to the
control amplifier location. Make sure the larger Ethernet-style connector is at the control amplifier
end.
NOTE: An auxiliary cable connection can be used to pair a BLUETOOTH
®
device or other
battery-operated audio device so users can play their own music with the vibracoustic bath.
Optional
Auxiliary-In
Cables
Transducer
Cables
Chromatherapy
Cable
(If Equipped)
Chromatherapy
Cable
Transducer
User Interface Cable
Ethernet Connector
User Interface
1188012-2-D 8 Kohler Co.