How to Guide

Product Information
Applicable product:
Bath whirlpool with integral apron – left
drain
K-1239-LA
Bath whirlpool with integral apron – right
drain
K-1239-RA
Fixture*:
Basin area:
Bathing well, bottom 46″ (1168 mm) x 24″ (610 mm)
Bathing area, top 54″ (1372 mm) x 27″ (686 mm)
Weight 105 lbs (47.6 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 63 gal (238.5 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7.5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
44 lbs/square foot (214 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow before drilling any holes.
Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
20"
(508 mm)
No change in measurements if connected with drain
illustrated. (K-7161-AF or K-7161M-AF)
8-11/16"
(221 mm)
1-11/16"
(43 mm)
3"
(76 mm)
2-7/8"
(73 mm)
1" (25 mm)
3-1/2"
(89 mm)
18"
(457 mm)
60" (1524 mm)
36" (914 mm)
1-1/4"
(32 mm)
1/2" (13 mm)
R. Max
Integral
Flange Detail
Recommended Faucet Area
1-1/2" OD
Roughing-In
K-1239-LA,K-1239-RA
MARIPOSA
®
BATH WHIRLPOOL WITH INTEGRAL APRON
MARIPOSA
®
BATH WHIRLPOOL WITH INTEGRAL APRON
1014710-1-
D