Specification

K-1283 (Continued) 6’ Removable apron ❑ 0 ❑ Other_____
K-1491 Bath pillow ❑ 0 ❑ Other_____
K-1601 Bath footstop ❑ 0 ❑ Other_____
Technical Information
Fixture*: *Approx. measurements for comparison only.
Basin area, bottom 50″ (1270 mm) x 24″ (610 mm)
Basin area, top 65″ (1651 mm) x 27″ (686 mm)
Weight 88 lbs (39.9 kg)
Water depth 14″ (356 mm) to overflow
Capacity 72 gal (272.5 L) to overflow
Amplifier/control: Power per channel V Hz
15 (rms) W 120 50/60z
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD): Amplifier/control, 120 V, 15 A,
50/60 Hz
Installation Notes
Install this product according to the installation guide. Ensure
that the bath, user interface, amplifier, and transducers are
functional before completing the installation.
Control amplifier fits 16″ (406 mm) center studs. A grounded
outlet within the wall framing must be within 24″ (610 mm) of
the planned control amplifier. Cables are included, 25’ (7.6 m)
each.
Floor support under bath must provide for a minimum of
39 lbs/square foot (190.4 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
10-1/4"
(260 mm)
72" (1829 mm)
1" (25 mm)
36" (914 mm)
No change in measurements if connected with
drain illustrated. (K-7166-AF)
Recommended Faucet Area
1-1/4"
(32 mm)
1/2"
(13 mm) R.
Integral Flange
Detail
20"
(508 mm)
3"
(76 mm)
2-7/8"
(73 mm)
3-1/2"
(89 mm)
1-1/4"
(32 mm)
18"
(457 mm)
1-1/2"
Bath Drain
*24"
(610 mm)
*10"
(254 mm)
*Recommended User
Interface Location
Control Amplifier
User Interface
3-3/16"
(81 mm)
11-3/4"
(298 mm)
14-1/2"
(368 mm)
7/8"
(22 mm)
3-1/2"
(89 mm)
5-5/8"
(143 mm)
Lumbar
Angle
42˚
21-1/4"
(540 mm)
Product Diagram
MARIPOSA
®
MARIPOSA
®
6’ VIBRACOUSTIC
®
BATH WITH INTEGRAL APRON
Page2of2
1202544-4-
A