Installation Guide

3. Complete the Installation
Secure Frame
Square the frame to the rim of the bath/whirlpool.
Secure the sides of the frame to the studs with the screws provided. Shim as necessary to fill any
gaps.
Secure the bottom of the frame to the subfloor with screws or floor anchors. Shim as necessary to fill
any gaps.
Secure the bottom of the frame to the subfloor with screws or floor anchors. Shim as necessary to fill
any gaps. Approximately 1/2″ (1.3 cm) of shimming will be necessary if installing this apron to the
K-1266/K-1267 bath/whirlpool.
Thread the carriage bolt out until it makes contact with the bath/whirlpool. Then secure by
threading the nut up against the backside of the support structure.
Secure Panel
Center the panel on the frame. Press the panel onto the frame so that each of the fasteners engage.
Finish the Installation
Install water-resistant wall material [1-1/2″ (3.8 cm) maximum thickness] to complete the finished
wall.
Install flooring material [2″ (5.1 cm) maximum thickness] to complete the finished floor.
Service
Using a flat-blade screwdriver, gently pry the bottom of the apron panel away from the apron
frame.
Support
Structure
Screw
Panel
Fastener
Frame
Panel
Flat-Blade
Screwdriver
Frame
Bath/Whirlpool
Subfloor
Square
Shim,
if necessary.
Carriage Bolt
Frame
ServiceSecure Panel
Secure Frame
Kohler Co. 5 1018323-2-C