12RES 12kW, 120/240V UL/CSA Manual

TP-6515 2/2114 Section 1 Specifications
1.5 Accessories
The following optional accessories are offered for the
generator sets.
1.5.1 Carburetor Heater
An optional carburetor heater is recommended for
improved cold starting in locations where the ambient
temperature drops below 0C (32F). The carburetor
heater prevents condensation and carburetor icing. The
heater requires a continuous source of AC power.
Install the heater between the engine air cleaner and the
carburetor. Plug the carburetor heater into a 120 VAC
receptacle. Verify that AC power is connected to the
generator set as described in the generator set
Installation Manual. The circuit must be backed up by
the generator set to provide power at all times.
See the generator set Installation manual for more
information.
Voltage 120 VAC
Thermostat ON
4 ± 3C (40 ± 5F)
Thermostat OFF
16 ± 3C (60 ± 5F)
Figure 3 Heater Specifications
2
GM19462
1. 120 VAC plug
2. Thermostat
1
Figure 4 Carburetor Heater
1.5.2 Battery Heater Kit
The battery heater kit contains a heating wrap to help
warm the battery in cold climates. See Figure 5. The
battery heater is equipped with a thermostat that turns
the heater on at 16- 18C (60- 65F) and off at 27C
(80F). Battery heaters are recommended for regions
where the temperature regularly falls below 0C (32F).
Note: Battery heaters are compatible with all
Kohler-supplied lead-acid batteries.* For other
battery types, check the battery manufacturer’s
instructions for any restrictions regarding the use
of battery heaters.
The battery heater requires a source of AC power. Verify
that AC power is connected to the generator set as
described in the generator set Installation Manual. The
circuit must be backed up by the generator set to provide
power at all times.
1. Battery heater wrap
2. Retaining strap or cable ties (included)
3. Power cord
1
2
3
Figure 5 Battery Heater (typical)