Manual

TP-6515 1/1116 Section 2 Operation
Control or Indicator
Item Description
LED display
Runtime hours Displays total generator set runtime hours while the generator set is running and
when no other codes are displayed.
Metering
display
Displays AC voltage (output), frequency, and battery voltage. Press the up or
down arrow when runtime hours are displayed to step through these displays.
Crank indication Displays CC_1, CC_2, or CC_3 to indicate the first, second, or third attempt to
start the engine. The last digit flashes during the crank cycle rest periods.
Software
version number
The software version number (v#.##) is displayed when entering configuration
mode. See the installation manual.
Fault codes Flashes a 2 - or 3-letter fault code to indicate various fault conditions. See
Section 2.6.
Keypad Select and
arrow buttons
Use the arrow buttons to step through the data displays. See Figure 2-3.
The keypad is also used for controller setup and adjustment. The setup and
adjustment functions are password-protected. Have setup and adjustments
performed only by an authorized distributor/dealer.
Generator set master
switch
Three-position
switch
Switch functions as the generator set operation and controller reset switch.
Figure 2-2 ADC-RES Controls and Indicators
2.3.2 Controller Keypad
The three buttons on the controller keypad are Select,
Up, and Down. See Figure 2-1.
When the generator set is running, the up and down
arrow buttons can be used to step through system data
displays as shown in Figure 2-3. After 10 seconds, the
display returns to engine runtime hours.
The buttons on the controller keypad are also used for
system configuration and adjustment. The system
configuration is factory-set and should not require
changes under normal operating conditions. Contact an
authorized distributor/dealer or service technician if
adjustments are required.
2.3.3 Generator Set Master Switch
The generator set master switch is located on the
junction box below the ADC-RES user interface. The
master switch positions are RUN, OFF/RESET, and
AUTO. See Section 2.5 for operation instructions.
D Generator set master switch in AUTO
D Step through using up or down arrow buttons
D After 10 seconds, display returns to runtime hours
tp6515
Engine Runtime
XXX.X hours
Output Voltage
VAC
Output Frequency
Hz
Battery Voltage
VDC
Figure 2-3 Data Displays