How to Guide

Product Information
Applicable products:
Bath whirlpool with chromatherapy lights K-1394-H2
Bath whirlpool less chromatherapy lights K-1394-H3
Fixture*:
Bathing well:
Basin area 54-1/2″ (1384 mm x 44″ (1118 mm)
Top area 61-5/8″ (1565 mm) x 54-1/2″ (1384 mm)
Weight 260 lbs (118 kg)
To overflow:
Water depth 19″ (483 mm)
Capacity 196 gal (742 L)
* Approximate measurements for comparison only.
Pump: (Qty. 2) V Hz A
Variable speed: 240 50/60 18
Included components:
Cut-out template 1006705-7
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 220-240 V, 20 A, 50/60 Hz
Heater 220-240 V, 20 A, 50/60 Hz, 4 kW
Installation Notes
NOTE: Pump protrusion beyond rim.
Install this product according to the installation guide.
Two separate 240 V electrical services required; one for the
pump/control, and another for the heater.
Floor support under whirlpool must provide for a minimum of
54 lbs/square foot (264 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
2" OD
3" (76 mm)
3-1/2"
(89 mm)
9/16" (14 mm)
2-3/4"
(70 mm)
21-1/8" (537 mm)
Ø 66" (1676 mm)
2-1/2" (64 mm)
3-1/2" (89 mm)
26-5/16"
(668 mm)
11-5/16"
(287 mm)
14-7/16"
(367 mm)
25"
(635 mm)
23-1/2"
(597 mm)
Pump/Control Access
48" (1219 mm) W x
18" (457 mm) H Min
Note: Pump Protrusion Beyond Rim
Drop-in cut-out Ø 64-1/2" (1638 mm)
No change in measurements if connected with
drain illustrated. (K-7167)
K-1394-H3
Roughing-In
K-1394-H2, K-1394-H3
RIVERBATH
®
66″ BATH WHIRLPOOL
RIVERBATH
®
66″ BATH WHIRLPOOL
1022210-1-
E