How to Guide

ManualsBrandsKOHLER ManualsBathtubs1418-G-0

Product Information

Applicable products:

Bubblemassage bath – less

chromatherapy

K-1418-G

Bubblemassage bath – with

chromatherapy

K-1418-GCR

Fixture*:

Basin area:

Bathing well 48″ (121.9 cm) x 27″ (68.6 cm)

Top area 60″ (152.4 cm) x 30″ (76.2 cm)

Weight 150 lbs (68 kg)

To overﬂow:

Water depth 16″ (40.6 cm)

Capacity 94 gal (355.8 L)

* Approximate measurements for comparison only.

Drop-in cut-out 70-1/2″ (179.1 cm) x 40-1/2″

(102.9 cm)

Blower

motor:

Heater V Hz A

300 W 220-240 50/60 3

Required Electrical Service

Dedicated circuit required, protected with Class A

Ground-Fault Circuit-Interrupter (GFCI) or Residual

Current Device (RCD):

Blower motor: 220-240 V, 15 A, 50/60 Hz

Installation Notes

NOTICE: If the blower motor and check valve are

relocated, the following two procedures are required: 1.

Provide two access panels. Locate one access panel at the

blower motor/control location and the other access panel at

the control box. 2. Relocate the blower motor and the check

valve together. Do not relocate one without the other.

Install this product according to the installation guide.

Floor support under the bath must provide for a minimum of

54 lbs/square foot (261 kg/square meter) loading.

A blower motor access panel is required.

If used, the optional apron must be installed before the

ﬁnished ﬂoor and wall materials are installed.

If installing a rim-mount faucet, make sure there is no

interference with drain overﬂow and circulating system before

drilling any holes. Consult local and national codes for

minimum air gap requirements if installing a spout on the

faucet deck.

Fixture conforms to tolerances in ANSI Standard Z124.1.2. All

dimensions are nominal.

42" (106.7 cm)

72" (182.9 cm)

K-1418-GCR

3" (7.6 cm)

1-1/2" OD

Blower Motor/Control Access

34" (86.4 cm) W x

15" (38.1 cm) H

20-1/8"

(51.1 cm)

22"

(55.9 cm)

5-1/4" (13.3 cm)

36" (91.4 cm)

11-3/4"

(29.8 cm)

No change in measurements with drain

shown. (K-7161-AF or K-7161M-AF)

1-1/16" (2.7 cm)

2-7/8" (7.3 cm)

3" (7.6 cm)

Roughing-In

K-1418-G, K-1418-GCR

MEMOIRS

6’ BUBBLEMASSAGETM BATH

MEMOIRS

6’ BUBBLEMASSAGETM BATH

1035475-1-

Summary of content (1 pages)

PAGE 1
K-1418-G, K-1418-GCR MEMOIRS® 6’ BUBBLEMASSAGETM BATH Roughing-In Required Electrical Service Product Information Applicable products: Bubblemassage bath – less chromatherapy Bubblemassage bath – with chromatherapy K-1418-G K-1418-GCR Installation Notes NOTICE: If the blower motor and check valve are relocated, the following two procedures are required: 1. Provide two access panels. Locate one access panel at the blower motor/control location and the other access panel at the control box. 2.