Dimensions Guide

Technical Information
Fixture*:
Basin area:
Bathing well 48″ (121.9 cm) x 27″ (68.6 cm)
Top area 60″ (152.4 cm) x 30″ (76.2 cm)
Weight 150 lbs (68 kg)
To overflow:
Water depth 16″ (40.6 cm)
Capacity 94 gal (355.8 L)
* Approximate measurements for comparison only.
Drop-in cut-out 70-1/2″ (179.1 cm) x 40-1/2″
(102.9 cm)
Blower
motor:
Heater V Hz A
300 W 220-240 50/60 3
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Blower motor: 220-240 V, 15 A, 50/60 Hz
Installation Notes
NOTICE: If the blower motor and check valve are
relocated, the following two procedures are required: 1.
Provide two access panels. Locate one access panel at the
blower motor/control location and the other access panel at
the control box. 2. Relocate the blower motor and the check
valve together. Do not relocate one without the other.
Install this product according to the installation guide.
Floor support under the bath must provide for a minimum of
54 lbs/square foot (261 kg/square meter) loading.
A blower motor access panel is required.
If used, the optional apron must be installed before the
finished floor and wall materials are installed.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
42" (106.7 cm)
72" (182.9 cm)
K-1418-GCR
3" (7.6 cm)
1-1/2" OD
Blower Motor/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H
20-1/8"
(51.1 cm)
22"
(55.9 cm)
5-1/4" (13.3 cm)
36" (91.4 cm)
11-3/4"
(29.8 cm)
No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF)
1-1/16" (2.7 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Product Diagram
MEMOIRS
®
MEMOIRS
®
6’ BUBBLEMASSAGETM BATH
Page2of2
1035475-4-
E