How to Guide

Product Information
Applicable product:
Bath whirlpool, custom pump K-1418-HC
Bath whirlpool, custom pump K-1418-HE
Bath whirlpool, custom pump K-1418-HH
Bath whirlpool, custom pump K-1418-HN
Fixture*:
Basin area:
Bathing well 48″ (1219 mm) x 27″ (686 mm)
Top area 60″ (1524 mm) x 30″ (762 mm)
Weight 140 lbs (63.5 kg)
To overflow:
Water depth 16″ (406 mm)
Capacity 94 gal (355.8 L)
* Approximate measurements for comparison only.
Drop-in
cut-out
70-1/2″ (1791 mm) x 40-1/2″ (1029 mm)
Pump: kW V Hz A
Variable-speed 1.5 240 50/60 11
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 220/240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
45 lbs/square foot (221 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
Pump must be relocated to custom position at the time of
installation. Provide adequate clearance.
This whirlpool is designed for drop-in installation only. It is not
suited for use in a three-wall alcove with an overhead shower.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
K-1418-HH Pump/Control Access
34" (864 mm) W x 15" (381 mm) H
K-1418- HN Pump/Control Access
34" (864 mm) W x
15" (381 mm) H
5" (127 mm)
Max
1-1/2" OD
72" (1829 mm)
36" (911 mm)
5-1/4"
(133 mm)
11-3/4"
(298 mm)
4"
(102 mm)
Max
3"
(76 mm)
Max
K-1418-HE Pump/Control Access
34" (864 mm) W x 15" (381 mm) H
6" (152 mm) Max
K-1418-HC Pump
Control
Access
No change in measurements if connected with drain
illustrated. (K-7161-AF or K-7161M-AF)
1-1/16" (27 mm)
42" (1067 mm)
2-7/8" (73 mm)
3" (76 mm)
20-1/8"
(511 mm)
3" (76 mm)
22"
(559 mm)
Roughing-In
K-1418-HC,K-1418-HE/-HH/-HN
MEMOIRS
®
6’ CUSTOM BATH WHIRLPOOL
MEMOIRS
®
6’ CUSTOM BATH WHIRLPOOL
1022384-1-
D