Installation Guide

113504-2-AA (A)
2 Kohler Co., Kohler, WI
TOOLS AND MATERIALS
REQUIRED
 Level
 Drill with assorted bits
 Socket wrench with 8”
extension and assorted sockets
 Tape measure
 Framing square
INSTALLATION
 Rough-in the supplies and
drain piping and trap.
NOTE: The supply stop handles
cannot extend more than 5” from the
finished wall when in the open
position.
 Install sufficient backing behind
the finished wall to provide a
secure material for the
anchoring devices.
 Apply five self-adhesive
gaskets (provided) to the top
edge of the pedestal.
Gasket
Top of Pedestal
 Mark the centerline on the floor.
 Position the pedestal on the
floor centerline so the mounting
hole is approximately 7-1/4”
from the finished wall.
 Carefully set the lavatory on the
pedestal.
 Move the pedestal as required
to ensure proper fit in the
desired location.
 Level the lavatory. Add more
self-adhesive gaskets as
needed to level the lavatory.
NOTE: The lavatory must be
supported by the pedestal.
 Check the lavatory placement.
 Mark the center of each
anchoring hole on the wall, and
mark the floor through the hole
in the pedestal bottom.
 Carefully remove the lavatory
from the pedestal. Then move
the pedestal from the area.
Mark Floor
Here
Pedestal
Finished
Wall
Anchoring
Holes