Installation Guide

1011304-2-A
2
Kohler Co., Kohler, WI U.S.A.
TOOLS AND MATERIALS
REQUIRED
 Level
 Drill with assorted bits
 Socket wrench with 8” extension
and assorted sockets
 Tape measure
 Framing square
INSTALLATION
 Rough-in the supplies and drain
piping and trap.
NOTE: The supply stop handles
cannot extend more than 5” (12.7cm)
from the finished wall when in the open
position.
 Install sufficient backing behind the
finished wall to provide a secure
material for the anchoring devices.
 Apply five self-adhesive gaskets
(provided) to the top edge of the
pedestal.
Gasket
Top of Pedestal
 Mark the centerline on the floor.
 Position the pedestal on the floor
centerline so the mounting hole is
approximately 7-1/4” (18.4cm) from
the finished wall.
 Carefully set the lavatory on the
pedestal.
 Move the pedestal as required to
ensure proper fit in the desired
location.
 Level the lavatory. Add more
self-adhesive gaskets as needed
to level the lavatory.
NOTE: The lavatory must be
supported by the pedestal.
 Check the lavatory placement.
 Mark the center of each anchoring
hole on the wall, and mark the floor
through the hole in the pedestal
bottom.
 Carefully remove the lavatory from
the pedestal. Then move the
pedestal from the area.
Mark Floor
Here
Pedestal
Finished
Wall
Anchoring
Holes