Installation Guide

1. Prepare Site
Prepare the site for the bath installation and blower motor installation. Refer to the installation
instructions packed with your bath.
Install the required access panel to service the blower motor.
Prepare routing paths for the PVC piping and the keypad cable. Follow all applicable building, fire,
plumbing, and electrical codes.
2. Disconnect
NOTICE: Do not cut the bath harness (pipes) for this installation. Cutting the bath harness will void the
warranty.
Remove the four blower mounting screws from the board.
Cut any cable ties that support the cord.
Remove and retain the screw that is holding the air harness on the blower motor discharge.
Disconnect the keypad cable connecting the blower motor and the keypad.
At the same time, support the air harness with one hand and slide the blower motor away from the
air harness. Set the blower motor aside.
Remove and retain the upper screw at the check valve.
Remove the check valve and the PVC elbow from the bath harness.
Prepare, install, and secure the bath. Refer to the installation instructions packed with your bath.
Screw
Blower Motor
Mounting
Screws
Air
Harness
Check
Valve
1037564-2-B 4 Kohler Co.