Installation Guide

1. Prepare the Site
NOTE: To simplify future servicing, install an access panel to reach the plumbing.
NOTICE: The remote valve may be installed anywhere on the deck. In order to allow
clearance for handle rotation, a minimum distance of 5-3/4″ (14.6 cm) is required
from the center of spout to center of valve.
Determine the mounting hole locations for the handshower holder (not supplied),
spout, and remote valve. Refer to the roughing-in dimensions above and the
roughing-in dimensions packed with the handshower holder for proper placement
and mounting hole diameters.
For a finished bath deck/rim less than 5/8″ (1.6 cm) thick: Install reinforcing
material to the underside of the deck/rim. The combined thickness of the
reinforcing material and the deck/rim must not exceed 3″ (7.6 cm).
CAUTION: Risk of property damage. Select a cutting tool appropriate for the
deck/rim surface type. Refer to the surface manufacturer’s instructions for the
proper cutting procedures.
NOTICE: Do not exceed a 1-1/2″ (3.8 cm) diameter for the spout and remote valve
mounting holes. Maximum contact area is necessary for a successful installation.
Carefully cut mounting holes for the spout, remote valve, and handshower holder.
Install or relocate the water supplies as needed.
Préparer le site
REMARQUE: Pour simplifier l’entretien futur, installer un panneau d’accès pour
atteindre la plomberie.
5-3/4" (14.6 cm)
Min/Min/Mín
7-15/16"
(20.2 cm)
11-1/8" (28.3 cm)
8-1/4" (21 cm)
5-5/16"
(13.5 cm)
4-1/4"
(10.8 cm)
4-9/16"
(11.6 cm)
8-15/16"
(22.7 cm)
2-1/8"
(5.4 cm)
2-3/16"
(5.6 cm)
8"
(20.3 cm)
1-1/2" D.
Ø 1-1/2"
1-1/2" D.
3" (7.6 cm)
Max/Max/Máx
5/8"
(1.6 cm)
Min
Min
Mín
1-1/2" D.
Ø 1-1/2"
1-1/2" D.
3/8" Nominal
1110056-2-C 4 Kohler Co.