Full Product Manual

46 TP-7092 4/23
Figure 34 Changing Settings
Changing Settings on the RDC2 Controller
1. Press the Select button to enter the main menu.
8. When the correct date is shown, press the Select
button. The saved date is shown.
Press:
Press:
Display:
Display:
Press:
Display:
Press:
Display:
Press:
Display:
Press:
Display:
Press:
Display:
Press:
Display:
Press:
Display:
Press:
Display:
Press:
Display:
Overview -->
1.2 h
Date -->
and Time
Date
05Dec2011
Date
05Dec
2011
Date
05Dec
2012
Date
05
Dec2012
Date
03Jan2012
Time:
01.49pm
<-- Return
Date -->
and Time
Genset State
Standby
2. Press the down arrow button until the desired menu
is displayed. See the Main Menu
section. Date and
Time are used for this example.
3. Press the Select button to enter the Date and Time
menu.
4. To change the date and time settings, press the
Select button again. The year will flash.
5. Press the up or down arrow buttons to change the
year.
6. When the correct year is shown, press the Select
button. The year is saved and the next setting
(month) flashes.
7. Repeat steps 5 and 6, using the arrow and select
buttons to set the month and the date.
OR
9. Press the down arrow button to step to the next menu.
10. Repeat steps 5 and 6, using the arrow and select buttons
to set and save the time.
Note:
To change from am to pm, press the up arrow key to
increase the hour until the correct hour and pm is
displayed.
11.
In the time format menu, press Select and then press the
up or down arrow button to change the format, 12 hr. or
24 hr. Press Select to save the displayed format.
12. Press the down arrow button. Return is displayed.
13. Press Select to return to the Date and Time menu.
14. Press the Up or Down arrow buttons to step to a different
menu.
15. Press Auto to signal the controller to exit the menus and
return to the generator set status display.
AUTO
Note:
If no buttons are pressed, the controller returns to the status
display after 5 minutes.