Installation Guide

TP-7091 2/2114 Section 1 Location and Mounting
1.6 Access the Air Intake Area
The battery, fuel system, and some electrical
connections are located in the air intake area. Remove
the enclosure panel to access the air intake area during
installation as described below. No tools are required to
remove and replace the service-side, air intake end, or
exhaust end panels.
1. Unlock and raise the enclosure roof.
2. The air intake panel hangs on four 20 mm (0.8 in.)
diameter bushings. Pull the air intake panel up and
off. See Figure 1-5.
3. To make the electrical connections, you will also
need to remove the cover panel over the terminal
block as shown in Section 3.1.4.
4. After all electrical connections are complete and
the battery is installed and connected, reinstall the
panels. Align the four angled slots on the panel
with the bushings on the enclosure and lower the
panel into place.
1. Roof
2. Air intake end panel
3. Service-side panel
4. Panel hanging bushings, qty. 4
ADV-8928
1
2
3
4
img1079
Figure 1-5 Removing the Air Intake Panel