Installation Guide

TP-7091 2/21 39Section 5 Accessories

img1061

1. 120 VAC receptacle location

2. Knockouts for 240 VAC plugs

Figure 5-5 Power Connections for Carburetor

Heaters

5.3 Programmable Interface

Module (PIM)

The optional programmable interface module (PIM)

shown in Figure 5-6 provides two programmable inputs

and six dry contact outputs, four of which are

programmable. See TT-1584 for PIM installation and

connection instructions. Also see Section 3.3 of this

manual for connection to the generator set.

The default settings for the inputs and outputs are

shown in Figure 5-7. To change the input and output

settings, use a personal computer running Kohler

SiteTech software. See TP-6701, SiteTech Software

Operation Manual, for instructions. SiteTech is

available to Kohler-authorized distributors.

Outputs 3 through 6 can also be controlled remotely

using the OnCue Plus program. If an output is

activated or deactivated through OnCue Plus, it is no

longer controlled by the RDC2 controller. Kohler

SiteTech software can be used to set the outputs back to

generator-controlled events, if necessary. See the

OnCue Plus manuals for instructions.

1. Output connections (3 terminal blocks, 6 outputs)

2. Input connections (2 inputs)

3. RBUS communication connection to generator set terminal

block TB2

ADV-8199

Figure 5-6 Optional PIM