Installation Guide

Tools/Outils/Herramientas
1.
Install the Bath Feet
WARNING: Risk of personal injury. Wear personal protective equipment and
obtain sufficient help to carefully lift or move the bath. Cast iron baths are
extremely heavy. Lift the bath properly to avoid personal injury.
If separate, loosely assemble the C-clamps to the bath feet using the washers and
nuts provided.
With help, carefully lift one side of the bath and wedge a stacked section of 2x4’s
or equivalent under the bath.
Position feet on the two exposed bath lugs, and apply between 11 and 12.3 ft lbs
(14.9 and 16.7 Nm) to the C-clamp nuts.
3/4" Open-End Wrench
Clé à fourche de 3/4"
Llave de boca abierta de 3/4"
Plus/Plus/Más:
• 2x4 Lumber
Montants de 2x4
Listones de 2x4
Torque Wrench
Clé dynamométrique
Llave de torsión
2-3/8" (6 cm) Adjustment
Réglage de 2-3/8" (6 cm)
Ajuste de 2-3/8" (6 cm)
3-13/16"
(9.7 cm)
Min/Min/Min
6-3/16"
(15.7 cm)
Max/Max/Max
C-Clamp
Pince en C
Prensa C
Washer
Rondelle
Arandela
Nut
Écrou
Tuerca
Leveling Bolt
Boulon de
mise à niveau
Perno de
nivelación
Leveling Bolt Nut
Écrou de boulon de mise à niveau
Tuerca del perno de nivelación
Bath Lug
Oreille de baignoire
Lengüeta de bañera
Bath Foot
Pied de baignoire
Pie de bañera
Torque the C-clamp nuts
between 11 and 12.3 ft lbs
(14.9 and 16.7 Nm).
Serrer les écrous des
brides en C entre 11 et
12,3 pi lb (14,9 et
16,7 Nm).
Aplique una torsión entre
11 y 12,3 lbs pie (14,9 y
16,7 Nm) a las tuercas de
las prensas C.
1171029-2-A 2 Kohler Co.