Installation Guide

4. Secure the Unit
Position the unit over the stud pocket.
Thread a fastener (provided) 1″ (2.5 cm) into the mounting hole at the top right corner.
Level the unit, then thread a fastener 1″ (2.5 cm) through the mounting hole at the top left corner.
Alternating from side to side, as shown, partially thread fasteners through the remaining mounting
holes.
WARNING: Risk of product damage. To avoid cracking the acrylic, do not overtighten the
fasteners.
Fully tighten the fasteners, starting at the top and alternating from side to side.
Using 100% silicone sealant, fill in the groove between the attachment flange and the wall material
around the perimeter of the unit. If needed, use a putty knife to press the silicone into the gap.
Wipe off any excess sealant.
Allow the sealant to cure before proceeding.
Seal between gap.
1" (2.5 cm)
Side View
1
3
5
7
9
2
4
6
8
10
Kohler Co. 7 1071450-2-B