Installation Guide

5. Complete the Installation – Freestanding

Apply lubricant (supplied) to the O-rings on the coupling

assemblies.

Insert the arms of the bath ﬁller onto the coupling assemblies.

Ensure the arms are ﬂush against the top of the riser tubes.

Secure the arms to the coupling assemblies with the large

setscrews.

Slide the tee assembly up to cover the seam between the arms

and the top of the riser tubes.

Insert the fastener rod to the center of the tee assembly, as shown.

Secure the tee assembly, with two small setscrews, below the

center of the tee assembly.

Remove the protective wrap from the riser tubes.

Secure the brackets at this location with small setscrews.

Proceed to the ″Install the Handshower - All Installations″ section.

Bracket

Arms

Riser Tube

Fastener Support

Coupling Assembly

Small Setscrew

Large Setscrew

1054455-2-E 10 Kohler Co.