Installation Guide

6. Prepare the Site - Deck-Mount

NOTE: Provide an access panel under the bath deck for water

supply connections.

NOTE: Reference the ″Rough-In - Deck-Mount Installation″ section

of this guide before proceeding.

Place the support plate onto the bath deck where the water

supply tubing will be located. (1)

Trace the holes of the support plate at this location to set the

centerline distances for the water supply tubing.

Verify that the location of the support plate will allow the spout

of the bath ﬁller to reach over the bath deck and into the bath. (2)

Verify that the distance between the centerline of the holes on the

support plate will be 5-29/32” (15 cm) ±0. (3)

NOTE: If a hole saw will be used to drill the holes, drill outside the

line of the marked holes.

Drill the marked holes on the bath deck using a 1-9/16” spade

drill bit or 1-1/2″ hole saw. Remove any debris from the drilling

process.

Verify the diameter of the drilled holes will accommodate the

diameter of the tubes. Adjust the hole diameter slightly, if needed.

Secure the support plate to the unﬁnished bath deck with the

eight (provided) wood screws. (4)

Check the

reach.

Bath Deck

Support

Plate

Screw

5-29/32" (15 cm) ±0

1-1/2" D.

1) 2)

3) 4)

Kohler Co. 11 1054455-2-E