Installation Guide

Tools and Materials

Before You Begin

NOTE: This product may be installed as freestanding (installed

onto riser tubes) or deck-mount (installed onto the bath deck).

Follow the sections that pertain to your installation.

For Freestanding Installations

NOTICE: Discard the following hardware provided with the bath

ﬁller: support plate (1), threaded brass tubes (2), nuts (4), ﬁber

washers (4), and screws (8).

NOTICE: Do not remove the protective wrap from the riser tubes

until instructed to do so.

For All Installations

Observe all local plumbing and building codes.

Shut off the water supply.

IMPORTANT! For proper drainage of the spout, install the bath

ﬁller to a level surface.

3 mm,

5/16", 1/4"

Solder

Plus:

• Two 1/2" NPT Male

Copper Connectors

• Two 12" (305 mm) Long,

1/2" Copper Tubes (Deck-Mount)

• Two 30" (762 mm) Long,

1/2" Copper Tubes (Freestanding)

Drill and

Hole Saw

Thermometer

Sealant Tape

Strap

Wrench

Hacksaw or

Tubing Cutter

1219580-2-A 2 Kohler Co.