Installation Guide

1. Assemble the Bath Filler
NOTE: The bath filler arms are NOT identical. The setscrew holes
on the long end of the arms should face each other.
Determine the left and right side arms.
Apply lubricant (provided) to the O-rings on the bath filler body.
Attach the short end of the arms to the bath filler body.
Usinga3mmhexwrench, secure each arm with a large setscrew.
Orient the handshower bracket with the large side of the taper
facing up.
NOTE: The handshower bracket should be assembled
perpendicular to the arm so the handshower hangs over the bath.
Slide the handshower bracket onto the arm for the hot water
supply.
Using a 5/16″ hex wrench, tighten the small setscrews to secure
the bracket at the desired height.
Arm
Arm
Large
Setscrew
Small
Setscrews
Handshower Bracket
(Large Side Up)
Bath Filler
Body
O-Ring
Kohler Co. 5 1219580-2-A