Installation Guide

18-5/8"
Notes
Required Electrical Service
Install this product according to the installation
guide.
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Connect the seat to a cold water supply of
drinking quality water at a pressure of 20 psi - 80
psi (139 kPa - 551 kPa).
120 V, 15 A, 60 Hz
Technical Information
Do not install this seat in a location where: (1)
water might be splashed on the product or (2)
All product dimensions are nominal.
ElongatedSeat shape type:
excessive moisture, high humidity levels, or
condensation is present. This will avoid damage
to the electronic components.
Closed-frontSeat front type:
5-1/2" (140 mm)Seat-mounting holes:
Do not use an extension cord with this product.
43" (1092 mm)Power cord length:
To avoid possible product malfunction, do not
plug in the seat until instructed to do so.
Locate the recepticle at least 6" (152 mm) above
the floor, and within a 32" (813 mm) radius
measured 2" (51 mm) from the bowl ledge.
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
9-28-2018 10:03
C3
®
-050
Elongated Cleansing Toilet Seat
K-18751