Installation Guide

Product Information (cont.)

Features

Factory-installed components include a blower motor with power supply cord, check valve (some models),

air piping, user keypad, and a heated surface with power supply cord, user keypad, and keypad cable.

-G2MW models also include transducers, an ampliﬁer, and a power supply cord. Other than electrical wiring

and plumbing, no assembly is needed.

Tools and Materials

Before You Begin

NOTICE: Adequate ﬂoor support must be provided. Note the model number on the components end of

the bath, then visit the product page at www.kohler.com for additional information.

NOTICE: Do not lift the bath by the piping or blower, or use the piping or blower for structural support

of the bath. To avoid damage to the bath, lift by the rim at the sides of the bath.

NOTICE: Before installing a rim-mount bath faucet, refer to the speciﬁcation sheet on the bath product

page at www.kohler.com.

NOTICE: For remote blower installations, refer to the installation instructions included with the remote

blower installation kit K-1446 before proceeding.

NOTICE: For -G2MW Music Models: Refer to the installation instructions included with the ampliﬁer for

wiring and installation details. Position the ampliﬁer anywhere within the shroud (not recommended) or

in a remote location. If installed within the shroud, the ampliﬁer will need to remain plugged into the

electrical outlet at all times.

NOTICE: For -G2MW Music Models: This installation requires installation of an electrical outlet within

24″ (610 mm) of the ampliﬁer location. Refer to the ampliﬁer installation instructions.

Observe all local plumbing and building codes.

Unpack and inspect the bath and components for damage. Return the bath and components to the

carton until installation.

To simplify future maintenance, make sure all plumbing and control board connections around the

bath are easily accessible.

Use conduit to route electrical wires from the circuit breaker.

Plus:

• Drop Cloth

• Shims

• 2x4

• Wood Blocks

• Gloves

Construction

Adhesive 100% Silicone Sealant

Kohler Co. 3 1237792-2-G