Installation Guide

TP-7091 2/21 45Section 5 Accessories

1. Heating element

2. Heating probe

3. Thermostat

4. Label

5. 120 VAC male connector (connect to breather tube heater)

GM101483

Figure 5-17 Oil Heater

Note: For Models 14RCA(L): If the generator set is

equipped with a carburetor heater, obtain kit

GM102228-S to replace the breather tube, air

cleaner spacer, and gaskets before installing the

breather tube and oil heaters.

If the generator set is equipped with a carburetor heater,

remove it before installing the breather tube and oil

heaters.

The breather tube heating element wraps around the

breather tube from the engine to the air cleaner.

Before installing the oil heater kit, drain the oil from the

engine. Insert the oil heater near the oil drain valve using

the coupling provided in the kit. The oil heater power

cord connects to the breather tube heater cord.

1. Engine

2. Pipe

3. Pipe coupling

4. Oil heater

Figure 5-18 Oil Heater, Typical

5.7.3 Alternator Weather Cover

The alternator weather cover is used to prevent frost

and snow build up on the alternator brushes.

Follow the instructions provided with the kit to install the

alternator weather cover onto the alternator end

bracket. See Figure 5-19.

IMG_1055

Figure 5-19 Alternator Weather Cover