Installation Guide

2. Install the Lavatory
Drill 1/4” mounting holes at the marked locations on the finished
wall and the floor.
Install the faucet and drain to the lavatory according to the
manufacturer’s instructions.
CAUTION: Risk of product damage. Do not overtighten the
wood screw. Overtightening may damage the product.
Move the pedestal over the drilled hole in the floor, and secure the
pedestal to the floor by carefully tightening the wood screw and
washer.
CAUTION: Risk of product damage. Do not overtighten the lag
bolts. Overtightening may damage the product.
Carefully set the lavatory on the hanger and pedestal. Level the
lavatory, and carefully secure the lavatory to the wall with lag bolts
and washers. Tighten until snug.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Kohler Co. 5 1016186-2-A