Installation Guide

2. Assemble the Vanity
NOTE: To protect the finished surface of the vanity, perform
assembly tasks on a flat, padded work surface.
Remove the drawer from the vanity base. Refer to the
″Remove/Reinstall the Drawer″.
Place the vanity base upside down on the work surface.
Thread the feet into the four threaded mounting holes on the
vanity base, as shown.
Turn the vanity base so the feet are resting on the floor.
Insert the posts into the four threaded mounting holes of the
vanity base, then hand tighten the posts. Do not overtighten.
Place the frame onto the posts. Carefully position the posts so all
four bolts pass through the holes in the frame.
Place a washer and nut onto each bolt.
Securely tighten the nut onto each bolt with the wrench provided.
Secure the knob to the drawer with the screw. Refer to the
instructions packed with the knob.
Vanity Base
Knob
Screw
Feet
Leveler
Frame
Bolt
Washer
Nut
Post
Leveler
Kohler Co. 5 1061218-2-A