Install Manual

TP-6906 6/1446 Section 3 Generator Reconnection
3.4 Changing System Settings
The RDC2 controller’s keypad and display allow the
installer to check and change the generator system
settings, if necessary. The system settings for each
generator model are set at the factory and should not
normally require changes. Check the genset system
settings and change them, if necessary, after generator
reconnection or controller replacement.
The following procedure explains how to change the
system settings. The procedure is also illustrated in
Figure 3-5.
Procedure to Change System Settings
1. Press the Select button to enter the main menu.
See Figure 3-3 and Figure 3-4. The Overview
screen will be displayed.
2. Press the down arrow button to navigate to the
Genset System menu. See Figure 3-4.
3. Press the Select button to enter the Genset System
menu. See Figure 3-5.
4. Press the down arrow button to step through the
generator set system settings to the setting that
you wish to change.
5. When the setting is displayed (for example,
System Voltage), press the select button. The
value will flash.
6. Press the up or down arrow buttons to increase or
decrease the setting.
7. When the desired setting is shown, press Select.
The value stops flashing and the new setting is
saved.
8. Press the down arrow to step to the next setting.
9. To exit, press the down arrow button until Return is
displayed. Press the Select button to exit the menu.
10. Press the AUTO or OFF button to exit the main
menu.
Note: If no buttons are pushed, the controller exits the
menus and returns to the generator set status
display after 5 minutes.
GM77569
2
1. Display
2. Select button
3. AUTO button
1
3
Figure 3-3 RDC2 Controller User Interface